THC Vape AQL with full documents guide
THC Vape is a specification decision before it is a price decision. Get the resistance, the capacity and the packaging right and the price conversation becomes short. Get them wrong and no discount will rescue the order.
Published 01 April 2026 · VapeWholesaleHub · Reading time 7 min
Unit price versus landed cost
If you are comparing three quotes for THC vape, compare the paperwork first. Test reports, artwork files, batch coding and the replacement clause tell you more about a supplier than the unit price on page one.
The cheapest way to lower your cost per unit is usually to remove a SKU, not to negotiate a discount. Fewer lines means larger runs, fewer changeovers and a better price at the same quality.
Payment terms for new accounts are normally a deposit with the balance against the bill of lading. Established buyers on a repeat schedule can move to terms after three clean shipments.
What we test before a carton is sealed
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
Cosmetic grading is written down, not argued about. Minor scuffs inside the tolerance band are accepted; anything that would make a customer put the unit back on the shelf is rejected. Your staff should never have to explain a finish defect to a paying customer.
After-sales, replacements and reorders
Technical questions usually arrive at the worst possible moment, which is why we answer them on WhatsApp as well as email. A photo and a two line message resolves most issues faster than a ticket.
We keep the specification sheet for every order on file. Two years later, when a customer asks whether a pod is compatible, the answer is a lookup rather than a guess.
- Document pack prepared per destination market
- Reference sample retained from every batch
- Private label files archived for future rebrands
- Mixed SKU cartons to spread first-order risk
- Standing reorder schedule with a fixed cut-off
- Specification locked in writing before production starts
Merchandising a small range well
Shelf position decides velocity as much as price. Keep THC vape products at eye level, one facing per SKU, and rotate the trial line every quarter so the display keeps earning attention.
Seasonality in THC vape products is real but smaller than most buyers assume. The bigger swing comes from restocking discipline, not from calendar events.
Specification summary
| Volume | 0.5 ml |
| Hardware | Ceramic core |
| Thread | Proprietary pod |
| Airflow | Adjustable |
| Window | Full glass |
| Packaging | Blister |
| Minimum order | 100 units per SKU, mixed cartons allowed |
| Lead time | 12 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
How do you handle repeat orders?
The specification is held on file against your account, so a reorder is a reference rather than a new brief. We recommend a standing schedule with a fixed weekly cut-off so stock lands before the shelf empties.
What is the minimum order for THC vape?
Standard configurations start at 200 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 500 units because of setup time on the line.
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
Related reading
Need a quotation on THC vape products?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz